How to Start the Heater
-
Turn On the Heater:
- Locate the control panel or switch.
- Press the heating icon or turn the rotary dial to start.
-
Set the Temperature:
- Adjust the temperature using the arrow keys or by turning the rotary knob.
- For digital controls, hold the "OK" button to switch between heating modes.
-
Fan Only Mode:
- Press the fan icon to switch to fan mode and adjust speed.
How to Turn Off the Heater
- Press the heating icon again or turn the knob to the "off" position.
Temperature and Altitude Use Range
- Altitude Range: Designed to function at altitudes up to 6000ft.
- The heater requires a decent charge to work. If your heater stops working the most common cause is a low voltage on your battery.
Fuel Consumption
- Petrol: 0.037 to 0.071 gallons per hour.
This range depends on the heat output level selected. Ensure your fuel tank has enough capacity for your intended use.
Important Notes:
- Keep the vehicle's fuel tank above half for the heater to run.
- Regularly check the heater's air inlet and outlet to ensure they are free from blockages.
- Ensure your battery is charged regularly and has good voltage.
Basic Troubleshooting Guide for the Road
1. Heater Doesn’t Turn On
- Check Power: Ensure the campervan battery is fully charged.
- Inspect Connections: Check the heater's control panel and power cables for secure connections.
2. No Heat or Low Heat
- Fuel Supply: Confirm the vehicle has adequate fuel.
- Airflow: Check the air inlet and outlet for blockages like dust or debris.
3. Heater Shuts Down Unexpectedly
- Overheating: Check that the heater's air intake and exhaust pipes are not blocked.
4. Error Codes Displayed
- Refer to the digital control's error message and restart the heater.
- For frequent errors, ensure the exhaust and intake pipes are clear. Then set the heater to ambient temperature for 15 to 20 minutes, and raise the temperature slowly every 3 to 5 minutes. Ignition faults can be caused by carbon build-up, so it may take several restarts, with the heater running longer each time. You may need to repeat this after the heater has been off for a while.
Quick Restart Steps After an Error
- Turn off the heater completely.
- Wait for 2-3 minutes.
- Restart the heater and monitor its operation.
For additional issues, contact our Customer Care Team.